In cooperation with KTC Cooling we have developed an extension set for watercooling solutions. With the analog sensor hub you can connect very thin analog sensors and Push-in water temperature probes. With the T-Flow flowmeter you can automatically monitor liquid speed and you can define temperature and liquid speed limits, which lead to an emergency switch-off.
T-Flow flowmeter
With the T-Flow we offer a flowmeter with a good measuring range at low pressure losses. You can connect up to 2 flowmeters. To improve measurement results you can choose in the T-Balancer software different measurement ranges. For the T-Flow the range "4sec" applies.
| modell: | plastic, white |
| jet: | 3.3 mm |
| impulse per litre: | 509 (with software calibratible) |
| maximum flow: | 6 l/min |
| magnets: | Ceramic Sr Fe O |
| temperature range: | -10°C to +65°C |
| winding | G1/4" |
| connection: | 3Pin-Molex (female) |
Water temperature
probe Push-In
This water temperature probe is a Push-In system. You can push it into a t-piece or into the compensation tank. A sensitive analog sensor is embedded in the plug. Up to 6 water temp probes can be connected to the T-Balancer.
The plug is made of either nickel, bronze or aluminium to ensure an optimal heat conductivity.
The sensor has a 30cm cable and is available with the diameters 8mm and 10mm.
Push-In T-piece
Push-In
T-piece for the implementation of a Push-in water temp probe.
Compatible: polyurethan-soft (PUR-W), Polyurethan (PUR), PMR 8mm or 10mm
Push-In connector 1/8"
Push-In
connector for the connection to a compensation tank.
Compability: Polyurethan-soft (PUR-W) 8mm, Polyurethan (PUR), PMR, G 1/8"